Improving the QCX-mini power

I recently built my second QCX-Mini, this one for 20 meters. It's such a fun a build and even more of a joy to operate. I took it out to my local park for a test run using my homebrew, end-feed, half-wave, multi-band antenna. When the radio came on, the band filled with signals from a CW contest. I tried to respond to a few station, but apparently no one could hear me. I texted a friend who lives nearby and he was able flip on his HF radio and verify that I was indeed getting out. 

Back at the house, I pulled up Hans' video on maximizing output power on the QCX and sat at my bench to work on mine. I hooked it up to an RF power meter and found my rig was putting out a whopping 1/2 watt. No wonder no one could hear me. 

I adjusted the L3 inductor by spreading out the windings and managed to get right at 4 watts. But regardless of how much more I worked with it and the other two inductors, 4 watts was the most I could get. So, following Hans' advice, I desoldered the inductor and remove two windings. Once I soldered it back on the board I was able to get just over 6 watts. Perfect! I closed up the radio and packed it in the bag. 

This weekend, I took it back out to the park. Again--being a Saturday--the band was jammed packed with contest signals. However, this time, after waiting for a pause in an exchange, I called a station sending CQ. Instantly he returned my call! I gave him the exchange and he sent, "TU." It worked! I had about an hour of daylight left, but I wound up with 14 QSOs, all of them solid exchanges. 

TinyPaddles are a HUGE deal!

As the Christmas holidays approached, I decided to give myself a small and inexpensive gift...a new set of paddles. Mind you, these aren't just any set up paddles. These are a SUPER tiny micro-paddles! Called the "TinyPaddle," they were designed built by N6ARA. You can buy a kit version, but I opted for the assembled set. I first saw these on Tom Witherspoon's (K4SWL) site, qrper.com. I finally ordered a set just before Christmas and they arrived before New Years.

These are indeed very small! The paddles are soldered onto a circuit board and the board is insterted into a 3D-printed holder. The assembled version comes with a case which is basically a 3D-printed sleeve to protect the paddles when stowed. I also ordered the cable. The both came with an adjustment tool to carefully bend the paddles in or out as a way of adjusting the feel of the paddles. He also sells a version with the male plug instead of the female jack, in case that fits your setup better.

After playing with them for a little bit, I have to say I really like them! No, they don't feel like a $200 set of paddles. But, then they only cost $24! They are perfect for backpacking, POTA (my use), SOTA (not in Texas!) or any other ultralight station bag. I'm a sucker for cool, lightweight, micro gadgets and these certainly fit the bill!